JOINTSEAL - C

USES
JOINTSEAL-C is ideal for sealing and waterproofing joints or cracks in concrete masonry or asphalt surfaces, both horizontal and vertical. JOINTSEAL-C can also be used for roof flashing and roof tile  JOINTSEAL-C is not suitable for contact with solvents or jet fuel. 

OUTSTANDING FEATURES

• Good expansion & contraction properties..
• Good mechanical properties, tensile strength, elongation and resilience. 
• Pliable and flexible.
• Heat stable, does not melt at high temperature up to 60 ^oC.
• Excellent adhesion; strong durable bond.
• Economical.
• Time saving, Single component, does not require mixing, thereby saves time.
• Oxidation resistant and durable.

Joint Dimension
Ideally the depth of the joint should be half the width. Horizontal joints deeper than 10 mm should be first filled with sand backer rod, fiber board fillet to a depth of 10 mm form the surface. Vertical joints should be filled with back rod, fiber board filler or other suitable filler to a depth of 10 mm from the surface. Do not use polystyrene or polyurethane backer rod. 

DESCRIPTION
JOINTSEAL-C. is a high quality, economy grade, cold applied, elastomeric modified bitumen compound.

The fiber board or backer rod can be adhered to the joint wall with this application of JOINTSEAL-C. The backer rod or other filler material is desirable to equalize the compression of the sealant induced by joint movement and to reduce the thickness of the sealant. On traffic bearing surfaces, the sealant should be slightly sanded to prevent sticking.

Sealant Thickness
Maximum sealant thickness should be 10mm.  It is recommended that the application takes place in two stages of 5 mm each, allowing 4-8 hours of curing time between each application in order to expedite curing and minimize shrinkage cracking.

CLEANING
Tools : Clean with kerosene
Hands : Use a hand cleaner or kerosene followed by soap and water.

PACKING
20-kg pails and 200-kg drums.

HEALTH & SAFETY
Contains petroleum distillate; flammable; keep away from open fire, sparks or other ignition sources. Wear protective clothing, gloves and goggles.
1 . Fire - Flammable when wet, flash point 40 °C.
2. Skin - Avoid repeated or prolonged contact; if contact occurs remove with hand cleaner that removes oil or grease; then clean with soap and water.
3. Eyes- Contact could cause irritation. If contact occurs flush with clean water.
4. Inhalation - Can cause dizziness. Remove to fresh air and if breathing difficulty persist administer oxygen.

TECHNICAL DATA-JOINTSEAL- C

The information given in this Technical Sheet is to the best of our knowledge based on laboratory tests and practical experience. However, as the product is often used under conditions beyond our control, we cannot guarantee but the product itself.